A detailed explanation on How to install an amp kit can be had from this article. These wiring kits of amplifier are much easier to work with as they are readily available as prepackaged ones eliminating the need to understand any complicated wiring. There is another major advantage with these kits. They are inexpensive as compared buying all the components individually and then wiring them.
In this article we will learn the steps to do this installation along with few tips and suggestions. Be careful in understanding all the steps outlined.
The things needed to do this job are wire stripper, soldering gun , drill which is optional, a wrench that is adjustable and a screw driver. Keep these things ready before starting the work . Let us look at the steps in detail.
The first step would be to ensure safety before proceeding with any wiring book. So the terminals of the battery are disconnected . While this detachment is being done positive terminal must be disconnected after the negative one. Next step is drilling for which we use drill. The size of the drilled hole must be such that it is possible to accommodate both the power supplying wire and the covering wire for protection from excessive heat.
The next step would be to use screw drivers to loosen the tight fitting of the panels on the doors of the car. This should be done in two sides of the car where there are door frames. The power wire has two ends. One end is connected with the hole and the other to the holder of the fuse. The power wire is run continuously until paneling is found and reached. It can even be made to pass under the carpets. After trunk of the car is reached the power wire is connected conical twin screw barrel with the positive terminal of amps. While doing this ensure the connection is tight and firm. Make it tighter using screw driver when connection is made after stripping of end of the power wire
In the next step grounding of wire is done. A bolt is located and then tightened to secure the connection tight with the ring . This ring is covered with the ground wire. Electrical tapes are used for remote wire connections. These remote extruder screw barrel wires are finally connected to the receiver’s output. The speaker wires are then made to connect with the positive and negative terminals of the amplifiers and speakers.
Take out the fuse which is present in the fuse holder. Power wire connection with the positive terminal is made correctly . To do this we need to remove and then again attach the terminal nut. The terminals are connected with the corresponding posts that is positive terminals with positive posts and negative terminals with negative ones. In the final step the fuse is put back into the holder Now let us look tips and warnings . If there are present in the fire wall there will be no necessity for drilling . Before installing an amp kit we need to check out the power needs and if amp kit can meet those power needs or not. Inserting the fuse back into the holder should be done only when all steps are completed that is only when all the wiring connections and attachments are made perfectly. Now the installed amp kit is ready to operate.
Thus we have learnt How to install an amp kit from this detailed article.